Home / All / Products /

Natural veneer construction and application

Natural veneer construction and application

Dec 14,2011
Wood composite natural veneer or fiberboard panels built from hardwood core and hardwood veneer surface. They look like real hardwood installation is not easy to isolate and than real wood, but a thin veneer laminate kitchen floors, from 1 / 32,3 / 16 inches. After the the perfect time to repair, you may not sand have a scenic the surface of your real wood, or maybe you may end up sanding during the entire veneer, totally unique made . far better work with an orbital sander. This will a lot more difficult, even so it will save you costly and time-consuming surprises you.
A pry bar from through the room with the floor merely the outer side.
2, high-quality hardwood floor cleaner cleaning floor. They will remove dirt and old wax can clog sandpaper. Together domestic hot water and floor cleaner, mop the earth with the solution, and then also let engineered veneer entirely dry before continuing.
3, separate rooms, the other house hanging upon the door sheet of plastic. Off central air conditioning system, sanding dust will never be contaminated because of it pull all of the other house.
4 Natural veneer perfect for coarse sandpaper, sand the ground of an orbital floor sander, starting at the center, and work at the extra edge. Keep the sander moving, site, and possible until finishing of all old sand. 50 sandpaper start, and regular checks. In the event that it clogs, or that should be dirty to alter to 36 grit. 36 Keep in mind when sanding. It may quickly wear surface.
5 sand on the corner, along side the track with only one floor sander with sandpaper hand sanding the edges. Use floor scraper to take the corner, you simply cannot achieve with Sandra completed. Pull as part of your scraper remove completed, smaller allow scraper to dig into the wood far corner. Edit your hand-polished scratch area.
6 vacuum on the surface, then re-sand it with fine sandpaper better future. 36 sandpaper whenever you start moving up to 50 #, should fabric such as 50 #, 80 # move. Doing this will remove grinding marks for the previous passage. Vacuum and repeat your following higher grade (either 80 or 100 mesh particle size). A final one off with Sandra is 100 sandpaper, in case you start with 36 #, you will find yourself more stages.
7 vacuum the ground again, then wipe making use of damp cloth to remove dust grain in addition to the gap from the parliaments raised. Finally, staining, repair natural veneer.
Contact Person



No.1 Room,3F,the Worker Culture Palace,No.99 Yong'an Street,Deqing County,Huzhou City,Zhejiang,China,313200
QR code